ADBS-3x1-30T3C Page 1 of 4
Installation Guide
ADBS-3x1-30T3C
3 x 1 Ceiling Menu Board Tilt
REQUIRED TOOLS
OPTIONAL TOOLS
• Power driver
• 13mm Hex socket
• Crosshead Screwdriver
• Spirit Level
COMPONENT & PARTS CHECKLIST
INSTALL GUIDELINES
A
ADB-PC
Pole Ceiling Fixture
QTY:3
Ref Part name
Qty
A1 Ceiling Plate
1
A2 Plate Covers
2
A3 M8 x 70mm Screw
3
A4 M8 Washer
12
A5 M8 Nut
4
A6 Plastic Anchor
6
A7 Coach Screw
6
A8 Open Wrench
1
A9 6mm Hex Key
1
A10 M8 x 60mm Screw
1
A11 End Cap
1
A1
A2
A9
A6 A7
A5
A8
A3 A4
A10 A11
TWO PERSON INSTALL RECOMMENDED.
• Read and understand Installation Safety Instructions before commencing installation.
• Atdec recommends that a professional AV installer or other suitably qualified person
install this product.
• Configurations should be installed in a symmetrical manner for optimal safety.
• Place rail supports (ADB-RPJ, ADB-RUJ, ADB-WP) evenly along the length of a Rail
segment to provide even loading of components.
• ADB-R175 requires two rail supports (ADB-RPJ, ADB-RUJ, ADB-WP) to support a load of
200lbs (100kg). If one rail support is used, the rail can only support 110lbs (50kg)
maximum load.
• Fasten ADB-RX symmetrically over the junction of Rail segments. Tighten the set screws
of ADB-RX firmly.
• Place ADB-P Poles and ADB-RPJ Rail Pole Joiners directly behind the centre of each screen.
• Ensure that each ADB-R Rail is supported by at least one ADB-WP Wall Plate.
• When attaching displays, attach in an order that ensures stability during installation.
Alternate the loading order such that loads are balanced across to system. Alternate the
side onto which screens are placed to distribute load evenly.
220lbs
100kg
