AG-110 SIP Gateway User Manual
3
．
Restore to factory default
If your AG-110 settings is in chaos or you can’t get the AG-110 IP to access it,
you can reset the device to factory default:
a) Power
off
b) Press reset button and power on
c) The PWR led will light
Æ
Then PWR , SYS, WAN and LAN led will blink
Æ
Then the PWR and SYS led light.
d) Release the reset button after about 15~20 seconds,
e)
The PWR, SYS, WAN and LAN led will blink for a while and then the PWR
and SYS led will light.
AG-110 will be reset to factory default after the above procedure, you can then
access AG-110 through its LAN port, please refer to access_AG110 for
details.
28
