On a Wall:
■
■
For proper mounting, the wall jack must be an AT&T 630B series connecting or mounting block.
1
2
3
Reverse the plastic hook that sits
in the earpiece part of the handset
cradle.
CAUTION:
Do not attempt
to unscrew the base from the phone.
To do so will expose you to a risk of
electrical shock.
4
5
6
Plug the free end of the mounting
cord into the modular wall jack. (Skip
this step if connecting the phone
directly to the 206 module).
2-10
Installing the Hardware
To attach the stand to the base of
the phone, gently place the phone up-
side down with the low end of the phone
to the right. Insert the tab on the narrow
end of the stand into the left slot on the
base of the phone. Then insert the other
tab into the right slot, pushing the stand
down and slightly inward until the tab
locks into place.
Place the phone/stand assembly
over the wall jack, pushing any excess
cord into the space inside the stand. To
mount the assembly on the wall, place
the screw keyholes on the stand over the
studs above and below the wall jack,
then pull the assembly down gently.
Insert the cord through the center
of the stand and plug it into the jack on
the bottom of the phone.
Plug one end of the handset cord
into the jack on the handset. Plug the
other end into the jack on the side of the
base. Place the handset in the cradle.
Place the Quick Reference card near the
phone. (You may want to place it on top
of the phone, so the card leans against
the wall.)
Go to step 7.
