AT&T OneVision DEFINITY G3 Guide, Installation And Connection Manual, Page: 136 / 287

6-22 Issue 2 April 1996
Connectivity
To Configure Data Modules
Procedure 2:
Set data
module
options Use the following steps to set the data module options.
Step Action
1 In a UNIX shell, enter the following command to change
to the uucp directory:
cd /etc/uucp
2 Use a UNIX editor to open the Devices file.
Example:
vi Devices
3 Ad d the following command:
Direct /dev/ttyxxx - g9600 direct
xxx = the name of the tty device that is connected to
the 7400B data module.
4 Write and quit the file.
Hint: See Appendix C for basic vi operations.
End