AT&T MERLIN PIus, Installer'S Manual, Page: 18 / 57

TABLE 1-6 Installing BTMl-2s on StatIon Intercom Numbers
2
3
4
5
Number of
Intercom
MERLIN Attendants
Number
1
11
2 11 and 12
3
11, 12, and 13
b Switch the BTMI-2 to “data” mode.
Place the MERLIN Attendant on a table or desktop, or
mount it using the mounting bracket:
a Using a #10 or smaller screw (wood, sheet metal,
concrete), attach the wall mounting bracket to a
vertical wall surface so that the hook end of the
bracket is down.
b Locate the keyhole opening on the underside of the
MERLIN Attendant with the hook on the bracket.
Slide the unit over the hook and down to secure.
CAUTION: Do not stack multiple MERLIN
Attendants; this will damage the units.
Make sure setup switches 1 and 2 are off, then plug one
end of the modular phone cord into the jack on the
back of the MERLIN Attendant labeled “to line.”
(See Figure 1-3.)
Plug the other end of the modular phone cord into the
BTMI-2. (See Figure 1-4.)
Plug one end of the power cord into the 10 VAC power
connector on the MERLIN Attendant.
1-10 Connecting the MERLIN Attendant