AT&T MERLIN LEGEND Release 3.1, System Programming Manual

Page: 685 / 887

Night Service
Programming Procedures
4–313
NOTE:
For Release 2.1 and earlier, after setting Start and Stop time for Night Service the
current day of the week for Night Service must be set using the following
procedure.
NightSrvce
®
Day of Week
®
Dial the current day of the week
®
Enter
®
Exit
If system programming information is being loaded into memory from a backup
diskette, the current day of the week must be reset.
Night Service can be turned off by using the following procedure:
NightSrvce
®
Day of Week
®
Dial
9
®
Enter
®
Exit
NOTE:
The current day of the week for Night Service must be reset if system
programming information is being loaded into memory from a backup.
Summary: Night Service with Time Set
Programmable by System manager
Mode All
Idle Condition Not required
Planning Form Form 9c, Night Service: Time Set
Factory Setting Not applicable
Valid Entries Day: 0 to 6; Time: 0000 to 2359
Inspect No
Copy Option No
Console Procedure To add or change start/stop time:
NightSrvce
®
Start
®
Drop
®
Dial start day and time
®
Enter
®
Stop
®
Drop
®
Dial stop day and time
®
Enter
®
Exit
To activate/deactivate:
NightSrvce
®
Time Control
®
Off
or
On
®
Enter
®
Exit
PC Procedure To add or change start/stop time:
0
®
6
®
A
+
P
®
Type start day and time
®
0
®
7
®
A
+
P
®
Type stop day and time
®
0
®
5
To activate/deactivate:
0
®
8
®
1
or
2
®
0
®
5