AT&T MERLIN LEGEND Release 3.1, System Programming Manual

Page: 409 / 887

Lines and Trunks
Programming Procedures
4–37
Toll Type
Use this procedure to specify whether users have to dial a toll prefix (1 or 0)
before dialing an area code and telephone number. (Your local telephone
company should verify toll prefix requirements for each line/trunk.)
This setting is used by the system to classify calls as local or long distance so
that appropriate toll restrictions can be applied.
NOTE:
This option applies only to loop- and ground-start trunks; it does not apply to tie
trunks or DID trunks.
Summary: Toll Type
Programmable by System manager
Mode All
Idle Condition Not required
Planning Form Form 2c, System Numbering: Line/Trunk Jacks
Factory Setting Toll prefix required
Valid Entries Required, Not required
Inspect No
Copy Option Yes
Console Procedure To program a single line/trunk:
LinesTrunks
®
Toll Type
®
Select entry mode
®
Dial no. of
the line/trunk
®
Enter
®
Exit
®
Exit
®
Exit
To program a block of lines/trunks:
LinesTrunks
®
Toll Type
®
Select block of lines/trunks
®
Toggle LED On/Off
®
Enter
®
Exit
®
Exit
®
Exit
PC Procedure To program a single line/trunk:
4
®
0
®
6
®
Type no. of the line/trunk
®
0
®
5
®
5
®
5
To program a block of lines/trunks:
4
®
0
®
Select block of lines/trunk
®
Toggle letter
G
On/Off
®
0
®
5
®
5
®
5