Equipment and Location Requirements
NUMBER OF
MERLIN II
ATTENDANTS
REQUIRED
The following equipment is supplied with the MERLIN II
Attendant:
Power cord with transformer
•
•
8-foot, 6-wire modular phone cord
•
Mounting plate
•
User’s Guide
Also required, but not supplied, is
a 517C13 Basic
Telephone (012) Module housed in a MERLIN II Release
3 system control unit. Up to four MERLIN II Attendants
can be connected to the module.
When the maximum of four MERLIN II Attendants are
connected to the module, no basic telephones intended for
call handling should be connected to any of the remaining
eight ports. However, when programming MERLIN 11
Attendant features, you can connect a basic Touch-Tone
telephone to one of the remaining eight ports to perform
the programming procedures.
NOTE:
If a 400 w/TTR module is present in the system,
there is no limit to the number of basic
telephones that can be connected to the Basic
Telephone module with Merlin II Attendant
units.
If a customer is using the MERLIN II Attendant only for
backup call handling or night service, only one
MERLIN 11 Attendant is required unless call volume is
heavy, as shown in Table 1-3. When call traffic is heavy,
the number of MERLIN II Attendants required at a site
depends on the number of calls the customer receives
during peak hours. Refer to Table 1-3 to determine how
many MERLIN II Attendants are required.
Equipment and Location Requirements 1-7
Summary of Contents for MERLIN II Attendant
Page 1: ...AT T MERLIN II COMMUNICATIONS SYSTEM MERLIN II Attendant Installer s Guide...
Page 21: ...FIGURE 1 4 Connecting the MERLIN II Attendant Connecting the MERLIN II Attendant 1 17...
Page 33: ...FIGURE 2 2 Supervised Transfer process 2 12 Programming Features...
Page 35: ...FIGURE 2 3 Immediate and Backup Call Handling 2 14 Programming Features...
