Installing a Single Carrier on a Shelf or Desk
■
You will not receive optimum performance if unit is placed on a desk or low shelf
■
Install as high as possible, leaving at least 6 inches (15.2 cm) between antennas
and ceiling if on high shelf
■
Never install or remove a radio module from a carrier that is plugged into a wall
outlet (hot insertion)
■
See “Key Components” earlier in this chapter for additional picture detail
1
Check to make sure the carrier’s power cord is
unplugged from the wall outlet before continuing.
Remove the plastic cap covering each radio
module’s card edge before installing the radio
modules in the carrier.
2
3
Starting from the leftmost slot (#1), insert each
radio module into the carrier by hooking it onto
the radio module mounting rod. Slowly swing the radio
module’s card edge into the card edge connector on
the back of the carrier.
4
When the card edge is fully seated, a snap lock on
the bottom of the radio module will engage.
2-14
Installing the MDW 9010
