Installation and Operations Manual
AT&T Proprietary (Internal Use Only)
—110—
IMPORTANT!
1. All of the zones in the Takeover Module are “normally closed” zones.
2. The loop resistance should be between 2.2K and 6K Ohms. If the loop
resistance is out of range, then the end of line resistor must be changed or the
wiring must be repaired.
WARNING:
The Takeover Module cannot be used to power or monitor any type of Fire or CO
detection zone.
The Takeover Module does not power or monitor PIR or Glass Break devices.
6.2.9.8 Specifications─Takeover Module
General Specifications
Wireless signal range
TBD 350ft, open air
Code Outputs
For device: Power up, Tamper, Low battery,
Supervisory, AC power, DC (battery) power.
For each Zone: Open, Short, Restore
Transmitter frequency
433.92MHz
Supervisory Interval
60-70 min
Peak Field Strength
TBD
Dimensions:
Approx 4.75 x 3.00 x 1.5 in
Weight
Approx 8.0 Oz
Housing
ABS plastic
Color
White
Operating Temperature
32ºF to 120ºF (0ºC to 49ºC)
Relative Humidity
5-95% non-condensing
Operating Voltage
9-16 VDC, TBDmA
Regulatory Listing(s)
UL, FCC part 15 (both pending)
Included Accessories
Mounting plate, two (2) screws, two (2) plastic drywall
anchors, one (1) 14VDC power supply
