Installation and Operations Manual
AT&T Proprietary (Internal Use Only)
—102—
Figure 65: Takeover Module
The Takeover Module will be installed at the location of the existing security cabinet. The
Takeover Module supports eight wired zones and includes wiring terminals for
terminating the wiring going to existing wired window/door contacts. The Takeover
Module communicates with the 433/915MHz Transceiver Module in the DLC Cabinet via
the proprietary one-way 433MHz communication protocol. In most installations the
Takeover Module will be installed adjacent to the DLC Cabinet, but in some installations
it may be installed in a different location in the home. All of the zones in the Takeover
Module act as supervised wireless zones in the DLS.
NOTE:
DO NOT connect the DLC Cabinet to an AC power outlet that is controlled by a
switch.
The Takeover Module is equipped with 24 hour battery backup. When the Takeover
Module is operating during a local power failure condition, it will not supply power to the
two-way 915MHz wireless keypads. The two-way 915MHz wireless keypads are
equipped with 24 hour battery backup.
When the Takeover Module is installed, it will only be used to takeover existing wired
window/door contacts. Wired sirens, smoke detectors, CO detectors and motion
detectors will be replaced with wireless sirens, smoke detectors, CO detectors and
motion detectors.
