Using the AT&T Digital Announcer
2.
NOTE:
The position of this switch has no effect in CMS or
contact activated start applications.
Using a small, pointed object such as the tip of a bent paper
clip, press the Reset button on the rear panel.
NOTE:
Unless you press the Reset button, the setting for the
Power Failure Answer option will not change.
Changing the Lengths of
the Announcements
At any time, you can change how the total message memory is
allocated between the two announcements. However, when you
perform this procedure, your recorded messages are destroyed.
To change the lengths of the announcements, perform the
following steps:
NOTE:
Make sure you know the total message memory for your
unit (that is, 64 sec, 128 sec, 192 sec, or 256 sec). To
determine the total message memory for your unit, refer to
the planning form (Appendix A).
1.
Refer to the table for the amount of message memory your
unit contains, and set switches #4 and #5 to specify the
length of time for message 1 and message 2.
3-8
