AT&T administration and, Installation And Maintenance Manual

Page: 229 / 404

Administering a New System
SETTING SYSTEM
A MERLIN
II
system can be set for two different sizes:
SIZE
small and large. The small setting is for systems
administered for eight or fewer lines. The large setting
is
for systems administered for more than eight lines. This
large size setting allows the system
to
accommodate Up
to
56 lines. Refer to the System Configuration Form for
Feature Module 2 or Form 1e, System Form-
Requirements and Options to determine the system size.
With a Display Console
1
2
3
4
5
Press
[System], [Size]
The size screen appears.
Enter administration mode by sliding the T/P switch to
P.
Press Conference twice.
The administration menu apperas
Continue administration or leave administration mode
Press
[Small]
for a small system or
[Large]
for a large
System.
You see the message "System is Re-starting..." The system
renumbers itself, then the administrationmenu appears on the
display
by sliding the T/P switch to the center position.
With a BIS-34D Console
1
2
3
4
Enter administration mode by sliding the T/P switch
to
P.
Press Conference twice.
Lights flash next to Adm Tel, Adm Pool, Message, and Speaker.
Press Message.
Light goes on steady next to Message. Flashing lights go off.
Dial #201
Two beeps Sound.
Administering a New System
3-21