TO ENTER
ADMINISTRATION
MODE
TO LEAVE
ADMINISTRATION
MODE
SUMMARY OF
ADMINISTRATION
PROCESS
Follow these steps to enter the administration mode:
1
2
Slide the T/P switch on the left side of the console to
P.
Press Conference twice.
On the DisplayConsole, the administration menu appears. On the
BIS-34D Console, lights start flashing next to
Adm Pool, Adm
Tel, Message,
and
Speaker.
To
center position.
leave administration mode, slide the T/P switch to the
Following is a Iist of the procedures that make up the
administration process. The procedures are listed in the
order in which they are performed.
●
Set system operating conditions
>
Set system size
>
Set system type
> Designate attendant positions
●
Perform flexible numbering (FM2 and R3 only)
●
Administer lines
>
Assign lines to pools
>
Specify toll type
> Specify Touch-Tone or rotary signaling on lines
●
Administer stations
>
Assign lines and line pools to stations
> ldentify analog voice terminal type
>
Identify jacks for voice announcement to busy
voice terminal feature
3-18 Before Administering a System
Summary of Contents for administration and
