AT&T 6386 WGS, Installation And Maintenance Manual

Page: 95 / 213

Installing the Switch Integration Software
The next step is to install the AUDIX Voice Power Switch Integration
Software. The diskette should be labeled for the System 25 or the System
75 as is appropriate. For certain stand-alone applications, this software may
be omitted. In that case, skip this section and continue with the section,
Verifying Software Components.
CAUTION
Do not use the diskette included with the DCP board (System 75).
It is for DOS only.
1
2
3
4
Insert the diskette into the floppy disk drive.
At the # prompt, type installpkg and press [Enter].
If you are installing the Switch Interface Software for the
System 75/DEFINITY, you will be asked which version of the switch you
are using.
Files are listed on the screen as they are moved to the hard disk.
When all copying has been completed, you will be prompted to
remove the diskette.
If the package will not load because another device is already using
interrupt 3, call the next tier of support for assistance.
After the installation has completed, remove the diskette.
If prompted for shutdown, press [Enter] to shutdown the system.
When prompted to reboot, press the [Ctrl]-[Alt]-[Del] keys
simultaneously to reboot the system.
Software Installation
3-19