Connecting Peripherals
5-5
_
______________________________________________________________________________________
_
______________________________________________________________________________________
_
______________________________________________________________________________________
CONNECTING THE PRINTER
This procedure describes how to connect and set up AT&T 570 or 571 printer hardware. You will set up
the printer software options in AUDIX Voice Power System R3.0 Software Installation, Chapter 7, Setting
Up Peripherals.
1. Unpack and set up the printer according to the instructions supplied with the printer.
2. Ensure that there is paper in the printer, the ribbon is properly installed, and the cover is closed. (The
printer will not enter set-up mode if it is out of paper or if the cover is open.)
3. Set the printer default values by completing the following steps a through f:
a. While holding down the
FUNCTION
and
SCROLL
↓
switches, turn the power ON.
The printer runs a set of self-test functions. When the self-test functions are complete, the
printer displays set-up function number 99.
b. Press
SCROLL
↑
to select set-up function number 98 (set default values).
c. Press
MENU
to enter menu mode.
d. Press
SCROLL
↓
to select menu item 02.
e. Press
FUNCTION
to set the default values.
f. Turn the power OFF.
4. Complete the following steps a and b to connect the printer to the WGS:
a. Plug the 25-pin connector end of the DB25 parallel printer cable into the parallel port (E) on
the WGS. Secure the connector with the captive screws.
b. Connect the other end of the parallel printer cable to the matching Centronics
port on the
printer. Secure it using the spring clips.