Atag DW7113XA, Operating Instructions Manual

Page: 158 / 169

Action Type of fault on the display
Clear the drainage pump. See the chapter Care and cleaning. If
the problem persists, call the service department. Overfilling water 1 F10
See “Water remains in the dishwasher” in the table “Problem”
below. If the problem persists, call the service department. Water outlet fault F11
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. See Unblocking the inlet hose filter in
the chapter Care and cleaning. If the problem persists, call the
service department. Water inlet fault F12
Turn off the water tap and call the service department. Inlet valve leakage F40
Clean the coarse and fine filters. Check that the outer filter on the
inlet hose is not blocked. If the problem persists, call the service
department. Water level fault F52
Turn off the water tap and call the service department. Overfilling water 2 F54
Call the service department. Circ. pump fault F56
Check that the water tap is on. Check that the outer filter on the
inlet hose is not blocked. See Unblocking the inlet hose filter in
the chapter Care and cleaning. If the problem persists, call the
service department. Water inlet fault F67
Press any button to clear the error message.
Action Possible causes Problem
Wait a moment then try again. You have pressed the buttons
too soon after opening the door. The buttons do not react when
pressed.
See the chapter Settings. Child lock (button lock)
activated.
Open the door. The buttons only
react to use when the door is
open. The door is closed.
Clean with a dry or slightly damp
cloth. The buttons are dirty.
28
Troubleshooting