Thank you for purchasing the ATA SecuraCode
®
PTX-4 keyring
transmitter. Familiarise yourself with the following instructions
prior to commencing set up. Store this information in a safe
place for future reference.
OPERATION
To open a door or gate using the transmitter simply press one
of the programmed channel buttons for two seconds. Each press
of the button will cycle through an open, stop or close action.
STORING TRANSMITTER CODE
Make sure to install the battery in the transmitter correctly.
1.
Press and hold the blue Door Code button on the opener or
SW1 or SW2 on the receiver board.
2.
Press the transmitter button you would like to use to control
the door for two seconds.
3.
Release and pause for two seconds. Press the same button
again for two seconds.
4.
Release the Door Code or SW button.
5.
Press the transmitter button to test operation of the door/gate
etc.
Note:
To remove a transmitter’s code from the device repeat
steps 1-5 above .
STORING TRANSMITTER(S) FROM A REMOTE
LOCATION
Using this method you do not need to have direct access to the
control panel or receiver. However, you do need a transmitter
that is already coded into the opener.
IMPORTANT NOTE: The door/gate or courtesy light will
be activated when the step below is performed. The
moving door/gate or light switching on is to confirm that the
correct button was pressed and the transmitter is in range
of the opener.
1.
Take any pre-coded transmitter. Press the button for the
function you require until the door/gate is activated and release.
2.
Then using a small needle press through the Coding Hole
and hold firmly for two seconds.
3.
Within 10 seconds take the additional transmitter you wish
to code.
4.
Press the transmitter button you would like to use to control
the door for two seconds.
5.
Pause for two seconds then press the same button again for
two seconds. This button should now be coded.
5.
Wait for 10 seconds, then press the just coded transmitter
button to confirm that it operates the door/gate etc.
DELETING ALL STORED TRANSMITTER CODES
1.
Turn the power off to the opener.
2.
Press and hold Door Code or SW1 button.
3.
Turn the power on again, while holding the button. The
Coding LED will illuminate to indicate that the receivers
memory has been deleted.
4.
Release the button. All the stored codes including the
courtesy light codes should now be deleted. Confirm this by
pressing the transmitters previously used to operate the device.
There should be no response.
PTX-4 SecuraCode
®
Keyring Transmitter
GDO-2 & GDO-4 Garage Door Opener Control Panel
CRX-2 Stand Alone Receiver
SW1 SW2
PTX-4 Transmitter Coding Instruction Manual
PTX-4 Transmitter Coding Instruction Manual
SW1 SW2
RX-2 V2.02 Receiver Board
WALL MOUNT
BRACKET
SMALL NEEDLE
CODING HOLE
© April 2004. All rights reserved. SecuraCode
®
is a registered trademark of Automatic Technology Australia P/L.
Printed for Export.
