3-21
Chapter 3: BIOS setup
Asmedia USB 3.0 Controller (USB32G1_E12)/(USB32G1_E34) [Enabled]
Allows you to enable or disable the Asmedia USB 3.0 controller. Configuration options:
[Enabled] [Disabled]
Asmedia USB 3.0 Battery Charging Support [Disabled]
Allows you to enable or disable Asmedia USB 3.0 battery charging support. Configuration
options: [Enabled] [Disabled]
3.5.8 APM
ErP Ready [Disabled]
Allows BIOS to switch off some power at S5 to get the system ready for ErP requirement.
When set to [Enabled], all other PME options will be switched off. Configuration options:
[Disabled] [Enabled]
Deep S4 [Disabled]
When enabled, the system in S4 state will further reduce power usage and power off the
USB and PS/2 devices. The system in deep S4 state can be woken up via the power
button, LAN devices or other devices except USB and PS/2 devices. Configuration options:
[Disabled] [Enabled]
Restore AC Power Loss [Power Off]
[Power On]
The system goes into on state after an AC power loss.
[Power Off]
The system goes into off state after an AC power loss.
[Last State]
The system goes into either off or on state, whatever the system
state was before the AC power loss.
3.5.9
Network Stack
Network Stack [Disabled]
This item allows user to disable or enable the UEFI network stack. Configuration
options: [Disabled] [Enabled]
The following two items appear only when you set the previous item to
[Enabled].
Ipv4 PXE Support [Enabled]
This item allows user to disable or enable the Ipv4 PXE Boot support.
Configuration options: [Disabled] [Enabled]
Ipv6 PXE Support [Enabled]
This item allows user to disable or enable the Ipv6 PXE Boot support.
Configuration options: [Disabled] [Enabled]
