Asus STRIX B250I GAMING, User Manual, Page: 61 / 78

ASUS STRIX B250I GAMING
3-13
Chapter 3
CFG lock [Disabled]
This item allows you to enable or disable the CFG lock. Configuration options:
[Disabled] [Enabled]
3.6.3 System Agent (SA) Configuration
The items in this menu allow you to adjust the Link Speed for PEG Port and Multi-Monitor.
3.6.4 PCH Configuration
PCI Express Configuration
This item allows you to configure the PCI Express slots.
PCIe Speed [Auto]
This item allows your system to automatically select the PCIe port speed. When set
to [Gen1], the PCIe port runs at PCIe 1.0 speed. When set to [Gen2], the PCIe port
runs at PCIe 2.0 speed. When set to [Gen3], the PCIe port runs at PCIe 3.0 speed.
Configuration options: [Auto] [Gen1] [Gen2] [Gen3]
3.6.5 PCH Storage Configuration
While entering Setup, the BIOS automatically detects the presence of SATA devices. The
SATA Port items show Empty if no SATA device is installed to the corresponding SATA port.
SATA Controller(s) [Enabled]
This item allows you to enable or disable the SATA device. Configuration options: [Enabled]
[Disabled]
SMART Self Test [On]
SMART (Self-Monitoring, Analysis and Reporting Technology) is a monitoring system that
shows a warning message during POST (Power-on Self Test) when an error occurs in the
hard disks. Configuration options: [On] [Off]
Hot Plug [Disabled] (SATA6G_1 (Gray) ~ SATA6G_4(Gray))
These items allow you to enable/disable SATA Hot Plug Support. Configuration options:
[Disabled] [Enabled]
3.6.6 PCH-FW Configuration
This item allows you to configure the firmware TPM.
3.6.7 Onboard Devices Configuration
HD Audio Controller [Enabled]
This item allows you to use the Azalia High Definition Audio Controller. Configuration options:
[Disabled] [Enabled]
RGB LED Lighting [On]
[On] The LEDs will always light up at the S0(Working), S3(Sleep), and S5(Soft
off) states, but not light up at the S4/S5 state when the ErP Ready item is
enabled.
[Off] The LEDs will not light up.