2-2
Chapter 2: Boot Agent Configuration
2.1
Intel(R) Boot Agent XE
The Intel(R) Boot Agent XE provides hardware-based Ethernet card configurations.
To start the Intel(R) Boot Agent XE and access the main screen:
1.
Turn on the system.
2.
During POST, press <Ctrl+S> when the following screen appears.
3.
From the
Setup Menu
screen, use the Up/Down arrow key to select an item and press
<Space> to change the value.
Initializing Intel(R) Boot Agent XE v2.3.58
PXE 2.1 Build 092 (WfM 2.02)
Press Ctrl-S to enter Configuration Menu
Intel(R) Boot Agent XE v2.3.58
Setup Menu
Network Boot Protocol
PXE (Preboot eXecution Enviroment)
Boot Order
Use BIOS Setup Boot Order
Show Setup Prompt
Enabled
Setup Menu Wait Time
2 seconds
Diagnostic Support Information
MAC Address 00E018122209 PBA Number FFFFFF-0FF
Memory DE180000 I/O E0000 IRQ 0A UMB C9000
PCI ID 8086/1563/1043/8712/01 Slot 0100
Flags 01810:4000:0000:0000:1103:L
Select remote boot protocol.
<Esc>
<Space>
<Enter>
<F4>
Cancel Changes
Change Value
Next Option
Save Configuration
Network Boot Protocol
This item allows you to select the boot protocol.
Configuration options: [PXE (Preboot eXecution Enviroment)]
Boot Order
This item allows you to select the order in which boot devices are queried.
Configuration options: [Use BIOS Setup Boot Order]
Show Setup Prompt
This item allows you to select whether Ctrl+S message appears during initialization.
Configuration options: [Disabled] [Enabled]
Setup Menu Wait Time
This item allows you to select the number of seconds to wait for Ctrl+S during initialization.
Configuration options: [0 seconds] [2 seconds] [3 seconds] [5 seconds]
