3
BEFORE USING YOUR REMOTE STARTER
Before leaving your vehicle, set the various controls in order to use your Remote
Starter.
Set heating/air-conditioning to desired position. (When Remote Starter starts your
engine, it will also turn on your climate control system.)
Make sure:
¾
windshield
wipers
are
“OFF”.
¾
gearshift
is
in
NEUTRAL;
¾
hand brake is ON;
¾
system has beeped once to confirm that it is ready to receive a command.
7
7
The system generates the beep to send a code every time key is not in ignition and
brakes are applied, or every time key is turned from “ON” to “OFF”.
Code 1
System ready.
If system beeps more than once (i.e., sends a code other than Code 1), refer to
following table to rectify situation.
Code 2
Gearshift is not in NEUTRAL.
Code 3
Hand brake is not ON properly.
Code 4
Sequence not recognized
U
.
Code 5
Programming problem. Contact your service center.
Code 6
Internal communication problem. Consult your service center.
U
This sequence is part of your Remote Starter’s safety system which constantly
checks position of your gearshift. This sequence is reset every time gearshift is moved
from any gear into neutral while hand brake is off.
USING MAIN SWITCH
Main switch is usually installed
under dashboard. It has 3 positions
- ON, OFF and LOW TEMP - and is
used to cancel start functions and
activate Sentinel Mode.