10
© 2017 Directed. All rights reserved.
•
Combo Valet (
x4 + )
The Combo Valet command is used to turn on/off both Alarm Valet and
Start Valet together.
- If both Valets are off then both will be turned on.
- If one or both Valets are on, then they will be turned off.
The 2-way remote control confirms by using LED and tones.
Manual Valet Modes
Use the following routine to manually turn on/off the Valet Modes, turning both
on manually achieves Combo Valet:
1.
Turn
the ignition ON and then OFF.
•
Alarm Valet:
Press
and
release
the Valet button once.
Alarm Valet will turn on/off accordingly. The antenna LED will be on
while Alarm Valet is on and will be off when Alarm Valet is off. The
siren/horn also sounds to confirm.
•
Start Valet:
Press
and
hold
the Valet button for five seconds.
The parking lights flash nine times in rapid succession when turned on,
and nine times in slow succession when turned off. The 2-way remote
control confirms by using LED and tones.
Emergency Override
The following procedure Disarms the system when a programmed remote is not
available. Number of presses__________
1.
Turn
the ignition ON.
2.
Press
the Valet button the correct number of times (the default is 1 press).
After a few seconds the siren output ceases and the system is Disarmed.
Battery Information
The 2-way remote control (2625-TX) is powered by two batteries (CR-2016).
The 1-way remote control (2615-TX) is powered by one 3V coin cell lithium
battery (CR-2032) that can be purchased at most retailers. When the battery
begins to weaken, the operating range will be reduced.
Summary of Contents for DSP615
Page 3: ......