17
CODE LEARNING OF ADDITIONAL TRANSMITTER(S)
Four different remote controls can be programmed for a given vehicle. If a fifth remote is added, the first remote is deleted.
Note
: When the first code learning command is sent, all the old codes are cleared out. therefore if you want to add a new
remote, all the old ones must be reprogrammed as well.
One or more remote transmitters can be added. To do this, the programming is accessed as follows:
Open hood
Place key in the ignition and turn to the RUN position
Apply the brakes once
You now have 10 seconds to turn the key from the RUN to the OFF position 3 times.
If this sequence is correctly carried out, the control module flashes parking lights (4 flashes). You may then
proceed to the next step.
Press the
button on the new remote control. When access code of new remote control is memorized,
the control module will confirm with flashing parking lights (1 flash).
Repeat the above procedures for each remote control that has to be programmed (up to 4 remotes).
Apply the brakes.
New remote(s) is (are) now added to the system.
SAFETY CHECKS
In order to maintain a high safety standard, proceed with the following checks every month.
HOOD SWITCH
•
Remote start your vehicle.
•
Open hood.
Engine should stop as soon as hood is opened.
If engine does not stop immediately, turn main switch to
OFF
position
and leave it off until situation is rectified.
Contact
your service center.
GEARSHIFT CHECK APPLICABLE TO AUTOMATIC TRANSMISSION VEHICLES
If key must be in ignition for gearshift to be moved out of
P
, your vehicle is safe as long as keys are kept away from children.
If, on the other hand, gearshift can be put in gear without key being in ignition, proceed with this simple check.
•
Put gearshift in gear (
D
).
•
Remain in the vehicle and be ready to apply brakes.
•
Start vehicle with remote starter.
•
Repeat these steps with gearshift in every position other than
Park
and
Neutral
.
If starter reacts within 90 seconds (which is not safe), turn main switch to OFF position
and leave it off until situation is
rectified
. Contact your service center.
•
With gearshift in
P
, start vehicle with remote starter.
•
Remain in vehicle and
be ready to apply brakes
.
•
Without applying brakes
, move gearshift out of P.
If, without applying brakes, engine does not stop immediately (which is not safe), turn main switch to
OFF
position
and leave
it off until situation is rectified.
Contact your service center.