Rewinder
QL-850 User Guide
105
5.
Align the rewinder [2] with the unwinder bracket [3]. Ensure the thumb screw mounting
locations align with the slotted holes on the bracket.
6.
Install the two thumb screws through the bracket [3] slots and into the rewinder [2].
Note: Do not fully tighten the thumb screws at this time. You will tighten the thumb
screws after ensuring proper alignment in the rewinding procedure.
7.
Plug the power jack into the power slot on the rewinder. Insert the power plug into an AC
power receptacle.
Rewinding Labels
The rewinder automatically winds printed media exiting the QL-850 onto rolls. The setup
process for rewinding labels requires an empty label core and tape.
Note: Do not turn the rewinder mandrel by hand to rewind the media. Turning the mandrel by
hand can result in rewinder damage.
1.
Ensure the power switch [3] on the rewinder is in the off position.
2.
Turn the thumb screw [6] counterclockwise to loosen and remove the removable roll
support arm [7].
3.
Turn the rewinder mandrel adjustment knob [4] counterclockwise to loosen the mandrel.
4.
Remove the outer flange [2] from the mandrel.
[1]
[3]
[2]
[5]
[4]
[6]
[7]
Summary of Contents for QuickLabel QL-850
Page 1: ...U S E R G U I D E...
