ASTRO ATS-309, Operator'S Manual, Page: 29 / 100

OPERATING TABBER
25
4. Loosen Head Stop and move it toward Head 2 to
permit moving Head 1 into position.
5. Pull on backing until a stamp starts to protrude
from Applicator (
peel point
).
6. Lower Pressure Roller Release Latch.
7. Refer to picture in Step 4 above , loosen Head 1 Securing Knob and slide Head 1
over Right Media Guide Assembly (
as shown
). Center stamp on outer edge of Guide
(
as shown
), and then tighten Securing Knob.
NOTE: This image shows how center point of stamp should align with exit end of
Right Media Guide Assembly. When initially adjusting stamp starting point, stamp
should just start to protrude from Applicator. It is important that stamp backing is
against side of Tab Sensor Guide in all cases. Sensor position is where notch in
Guide is positioned.
8. Close Exit Roller Assembly and lock two latches to secure it.
IMPORTANT
IF TABBER FOR IS NOT PROGRAMMED FOR TABBING JOB,
REFER
“ PROGRAMMING A JOB ”
SECTION FOR INSTRUCTIONS.
ONCE COMPLETE, RETURN TO THIS PROCEDURE.