Astria.US.com
126823-01C
28
OPERATION
NOTICE: During initial operation
of new heater, burning logs will
give off a paper-burning smell.
Orange fl ame will also be pres-
ent. Open damper or window to
vent smell. This will only last a
few hours.
WARNING:
• If fi replace has glass doors,
never operate this heater with
glass doors closed. If you op-
erate heater with doors closed,
heat buildup inside fi replace
will cause glass to burst. Make
sure there are no obstructions
across openings of fi replace.
• You must operate this heater
with a fi replace screen in place.
Make sure fi replace screen is
closed before running heater.
WARNING: Damper handle
will be hot if heater has been
running.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fi re or explosion may result
causing property damage, per-
sonal injury or loss of life.
A. This appliance is equipped with an igni-
tion device which automatically lights
the pilot. Do not light pilot by hand.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the fl oor because some
gas is heavier than air and will settle
on the fl oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
• If you cannot reach your gas supplier,
call the fi re department.
C. If any portion of this appliance does not
operate as the instructions indicate,
do not try to repair it, call a qualifi ed
service technician. Do not use tools.
Force or attempted repair may result
in a fi re or explosion.
D. Do not use this room heater if any part
has been under water. Immediately call
a qualifi ed service technician to inspect
the room heater and to replace any
part of the control system and any gas
control which has been under water.
LIGHTING
INSTRUCTIONS
1. STOP! Read the safety information.
2. Make sure equipment shutoff valve is
fully open.
3. Press any button on the remote to power
the remote on. Press the MODE zone or
the MODE/SET Button to start the unit.
You will hear a beep from the control
module and the pilot will start to light the
unit.
NOTE: You may be running this heater for the
fi rst time after hooking up to gas supply.
If so, you may have to restart the unit
several of times to allow the air to bleed
from the system.
TO TURN OFF GAS
TO APPLIANCE
1. Once you have activated the screen press
the MODE Zone or MODE/SET Button
until you see OFF.
2. Close equipment shutoff valve.
