NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE
HEARTH PRODUCTS
KITS AND ACCESSORIES
CAUTION
RISK OF PERSONAL INJURY OR PROPERTY DAMAGE.
•
Do NOT abuse glass doors by striking or slamming shut.
•
Never operate fireplace with glass door assembly removed.
•
Handle glass door assembly with extreme care. Replace
damaged glass door assembly with approved replacement
assembly only.
•
Use only media approved for use with these fireplaces (as
applicable). Failure to use approved media may result in sooting,
delayed ignition, or other improper fireplace operation, and may
void the warranty.
P900005-06
GLASS MEDIA KIT
P/N 900005-06
Rev. NC 10/2014
INSTALLATION INSTRUCTIONS FOR GLASS MEDIA KITS
FOR USE WITH ENVY CD DIRECT-VENT GAS FIREPLACES
[FIREPLACE MODELS ENVYCD35TEN, ENVYCD40TEN, AND ENVYCD45TEN]
NOTICE
•
READ ALL STEPS BEFORE STARTING INSTALLATION.
•
LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE.
•
All warnings, precautions, and instructions in the Installation
Instructions and Care and Operation Instructions provided with the
appliance also apply to these instructions.
•
If you encounter any problems, need clarification of these
instructions, or are not qualified to properly install this kit, contact
your local distributor or dealer.
General Information
This document contains installation instructions for the glass
media kit used with Signature Series ENVY CD direct vent
gas fireplaces.
DO NOT
install the glass media until the appliance installation
has been completed, the gas line has been connected
and tested for leaks, and the initial burner operation has
been verified.
Kit Contents
•
Glass Media, 5 lb bag (1)
•
Installation Instructions (1)
Required Tools
•
Safety Glasses
•
Protective Work Gloves
Table 1: ENVY CD Series Glass Media Kits
Description
Cat. No.
Model
Sky
H9021
GB-SKY
Midnight
H9022
GB-MIDNIGHT
Rain
H9023
GB-RAIN
Sunset
H9024
GB-SUNSET
Cloud
H9025
GB-CLOUD
Accessing the Firebox
Hot Fireplace Will Cause
Severe Burns
Never Allow Children to
Touch Glass or other Fire-
place Parts
WARNING
CAUTION
INSTALL ONLY WHEN FIREPLACE IS OFF AND COLD!
1.
Use the fireplace remote control to ensure the fireplace
is OFF.
2.
Turn OFF the gas supply and electrical power to the fireplace.
3.
Remove the top louver.
4.
Remove the left and right side finish trim gap fillers.
5.
Remove the surround trim assembly by detaching it at the
top of the fireplace and lifting it 1 in. to disengage the side
tabs, then pulling it away from the fireplace exposing the
front glass door (
Figure 1
).
6.
Locate the four (4) spring-loaded latches; two above and
two below the enclosure (
Figure 2
).
7.
Release the lower latches, by pulling each handle out
and down to unhook it from the glass door. Lightly press
against the door, to hold it in position, while releasing the
two upper latches.
NOTE:
Turn OFF the appliance and allow it to completely cool
before installing this kit.
WARNING
HOT GLASS WILL CAUSE BURNS.
DO NOT TOUCH GLASS UNTIL COOLED.
NEVER ALLOW CHILDREN TO TOUCH GLASS.
•
Install only when fireplace is OFF and COLD.
•
Fireplace surfaces get EXTREMELY HOT!
•
The glass on the front of the fireplace reaches EXTREMELY HIGH
temperatures and can cause severe burns if touched. Even after the
gas is turned off, fireplace surfaces remain extremely hot.
•
Keep children away from an operating fireplace. Closely supervise children in
any room where a fireplace is operating to prevent contact with glass.
f i r e - p a r t s . c o m
