81
Device options
Silent charging
The handset does not give an acoustic signal for any calls when it is in the char-
ger cradle. When you take it out, calls are acoustically signalled again. The calls
are recorded in the call list.
“Silent Charging“ will not apply when the handset is charged via the USB con-
nector (Aastra 620d, 630d).
Auto. key lock
If this option is active, the keyboard is automatically locked after approx. 60 sec
if no key is pressed.
Auto. answer (charger)
If this feature is active, the handset automatically answers a call if it is taken out
of the charger cradle.
Auto. answer (call)
With this feature the handset answers a call automatically. Only activate this
feature if your work requires it as it is then possible for the caller to listen in
unnoticed. For safety reasons Auto answer is initiated using 3 attention tones
and its actuation is signalled during the call by the rapidly flashing green LED.
This feature is useful if you need to be informed immediately about important
matters (e.g. when on standby). This feature also simplifies procedures when
operating the handset with a headset. Press Change to activate or deactivate.
You can set the following options*:
Time
Sets the amount of time after which Auto answer should be activa-
ted: 0 ... 20 seconds.
Please note: If your device supports the features Text messaging
and/or Paging, do not set any value under 3 seconds.
Handsfree
Allows you to answer the call in handsfree mode (activates the
loudspeaker). The In charger only or Always settings are used to
specify whether the handsfree feature should be activated only
when the handset is on the charger or also when you are carrying
the handset with you.
Microphone
Lets you answer the call automatically with or without activated
microphone. You can also activate the microphone after the call
using the softkey
.
LED indication
Lets you activate or deactivate the LED indication during a call.
80
Display
Here you can select for how long the full display illumination (each time a key is
pressed, for instance) remains active (10 ... 240 s).
Keyboard Here you can select for how long the keyboard illumination remains active each
time a key is pressed (1 ... 240 s).
Charger
Here you can select for how long the display illumination remains active if the
device is placed in the charger cradle (off, 1... 240 sec.).
Conversation
To save battery energy, you can use this feature to specify the behaviour of the
display illumination during a call (light off, on, dimmed).
LED indications
You can switch the LED indicators on/off according to requirements (see also
page 17 ).
Life indication
Slowly flashing green or orange LED.
Incoming call
Rapidly flashing green or orange LED for
incoming call.
Out of range
Rapidly flashing red LED if you are moving out of the
system's radio range
Charge indication
LED lights up orange when the battery is being
charged and switches to green when fully charged.
Infos
Slowly flashing red LED for a new entry,
e.g. in the call list.
Handsfree
Lights green LED when the loudspeaker
is activated.
Appointment
Slowly flashing red LED when the appointment
is signalled.
Alarm clock
Slowly flashing red LED when the alarm time
is signalled.
List access
The caller list and/or redial list are normally administered on your handset (setting: Local). If
a list is also managed in the communication system (setting: PBX), you can select which list
you want to display. Select Automatic to ensure that the device always uses the list (where
available) from the PBX communication system. If the list is not available, the automatic
selection remains on Local. Selecting PBX (or Automatic / PBX) makes sense if your handset
is operating in parallel with corded phones. This ensures that both devices have access to
the same list and that any changes made are visible on both devices.
Devices menu
Devices menu
