6.0 ACE Target cold start procedure
6.1 ACE Target cold start for Red Hat 5.X
The following sections provide cold start procedure instructions for ACE Target versions 4.13
and higher.
Important
: Before installing the software, ensure the Boot Priority settings are in accord-
ance with the proper BIOS configuration instructions. Otherwise, the Telestra Target does
not boot from the DVD but automatically enters the installation routine.
6.1.1 Install Red Hat 5.10 and higher
To install Red Hat 5.10 and higher, follow these steps:
1. Power on the Telestra Target via the power switch.
2. Insert the Telestra ASTi Software Installation DVD, and wait for the system to boot from
the DVD.
3. At the prompt, select
RHEL Target [Default]
.
Important
: For ACE Target versions 4.30 and lower, the prompt screen is different.
At the prompt, type
target
, and press Enter.
Figure 8: ACE Coldstart Menu
Copyright © 2018 Advanced Simulation Technology inc.
17
ACE Target and Studio Cold Start Guide (Rev. B, Ver. 0)
