Asterisk AsReader ASR-023B, Setup Manual, Page: 13 / 70

ASR-023B Scan Module Setup Manual
ASTERISK, INC. 12
Duration in scanning (Default: 3.0 sec.)
2.5. Output Interval of the Same Code
To avoid reading the same barcode multiple times in continuous mode and automatic
induction mode, set the scan engine to allow reading the same barcode after a delay.
Output interval of the same code is to refuse to read the same barcode within the set
length of time.
Default: 500ms, unit:100ms, range: 0-9900ms
To set output interval of the same code, scan the barcode below. Next scan two
Numeric Barcodes in appendix that correspond to the desired time-out. Single digit
values must have a leading zero. For example, to set a time-out of 0.5 seconds, scan
the barcode below, then scan the “0” and “5” barcodes. To change the selection or
cancel an incorrect entry, scan Cancel in appendix.
Output interval of the same code
2.6. Quick set for output Interval of The Same Code
None