BATTERY PRECAUTION
Necklace Panic Button Battery: (1)A23S Battery
Wrist Panic Button Battery: (2) CR2016 Batteries
When red LED is on (base unit), the backup batteries are low.
If the LED on Necklace Panic Button turns red when Necklace Panic Button is pressed, it is
time to change the battery.
If the LED on the Wrist Panic Button dims when the Wrist Panic Button is pressed and held,
it is time to change the battery.
Pairing the Pendants to the Base: If the base does not beep when the pendant is pressed it may need
to be ‘re-paired’ to the Base. Follow the instructions below to pair both pendants to the Base.
1. Turn power Off. (on Base Unit)
2. Turn power On
3. Within 4 seconds, press and hold the Big Blue Help Button on the Base Unit.
4. Then while still holding down the Big Blue Help Button on the Base Unit, press the Panic Button
on the Necklace Pendant or the Wrist Pendant. (In one second, you will hear a small beep) This
means the pairing was successful.
5. Pairing will automatically erase other pendants that were previously paired, so you will have to
perform the steps again for each pendant.
6. Turn Base Unit off.
7.Turn Base Unit On. Wait for Red LED to stop flashing.
8. Press a Pendant to Activate Alarm. (This is to test the pairing process)
Assistive Technology Services
“Our mission is to provide evaluation, consultation, spiritual
guidance and assistive devices to make the quality of life better
for those that need a little help.”
Visit our website:
AtsCares.com
SERVICE ANIMAL ALERT
email:
Phone:
615-562-0043
v050819d
