Congratulations on your new automatic door!
ASSA ABLOY Entrance Systems AB has developed automatic doors for more than 50 years. State-of-
the-art technology and carefully tested materials and components provide you with a superior
product.
As with all other technical products, your automatic door requires periodic maintenance and service.
It is essential that you know your automatic door (system) and that you recognize the importance
of maintaining it in compliance with applicable standards for safety.
Your local ASSA ABLOY Entrance Systems-authorized representative is familiar with these standards,
as well as all applicable local codes and ASSA ABLOY Entrance Systems recommendations for power-
operated pedestrian doors. Service and adjustments performed by your ASSA ABLOY Entrance
Systems-authorized representative, will ensure safe and proper operation of your automatic door
unit.
Electronic equipment reception interference
The equipment may generate and use radio frequency energy and if not installed and used properly,
it may cause interference to radio, television reception or other radio frequency type systems.
If other equipment does not fully comply with immunity requirements, interference may occur.
There is no guarantee that interference will not occur in a particular installation. If this equipment
does cause interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
•
Re-orient the receiving antenna.
•
Relocate the receiver with respect to the equipment.
•
Move the receiver away from the equipment.
•
Plug the receiver into a different outlet so that equipment and receiver are on different branch
circuits.
•
Check that protective earth (PE) is connected.
If necessary, the user should consult the dealer or an experienced electronics technician for additional
suggestions.
Environmental requirements
ASSA ABLOY Entrance Systems products are equipped with electronics and may also be equipped
with batteries containing materials which are hazardous to the environment. Disconnect power
before removing electronics and battery and make sure it is disposed of properly according to local
regulations (how and where) as was done with the packaging material.
Product liability
According to regulations, the following are the responsibility of the owner or caretaker of the
equipment
•
that the equipment operates correctly, so that it gives sufficient protection in regard to safety
and health
•
that the equipment is operated and regularly maintained, inspected and serviced by someone
with documented competence in the equipment and in applicable regulations
•
that the provided “Service Log Book” and “Site Acceptance Test and Risk Assessment” documents
(PRA-0003) are kept available for maintenance and service records
•
that inspection covers the emergency opening function (when applicable)
•
that the closing force is appropriate for the door size on fire-approved door systems (when ap-
plicable).
5
Issue 2020-10-09
1014896-en-7.0
