Copyright © 2017 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
80-9363-0001-020 Rev 7 08/17
1) READ AND FOLLOW ALL INSTALLATION
INSTRUCTIONS.
2) Install only on a properly operating and balanced door. A
door that is operating improperly could cause severe
injury. Have qualified service personnel make repairs to
any hardware before installing the operator.
3) Remove, or make inoperative, all locks (unless
mechanically and/or electrically interlocked to the
power unit) that are connected to the door before
installing the operator.
4) Do not connect the door operator to the source
power until instructed to do so.
Pull Side Back Plate Mounting Sequence
IMPORTANT INSTALLATION INSTRUCTIONS
Page 4
IMPORTANT BEFORE STARTING: RH DOOR SHOWN WITH HINGE ON LEFT AND PULLS TOWARD
YOU. FOR LH DOOR WITH HINGE ON RIGHT, ROTATE BACK PLATE 180°. NOTE: THE 4-7/8”
CONDUIT HOLES ARE ALWAYS LOCATED ON THE LATCH END OF THE DOOR. FOR DOORS
THAT MOUNT ON THE OPPOSITE SIDE OF THE FRAME (DOOR PUSHES AWAY FROM YOU), SEE
PUSH SIDE TEMPLATE. USE TEMPLATE FOR THE FOLLOWING INSTRUCTIONS.
Step A: Measure and mark frame for first mounting hole (see template). Drill using #7 drill and tap
hole using 1/4-20 UNC-2A tap if using 1/4-20 machine screws. If self-drilling self-tapping
screws are used, drill first mounting hole using a 3/16” drill and supplied screw.
Note:
Holes used for mounting the Back Plate are marked with a center mark on pull side
template at the back of this instruction.
Step B: Attach Back Plate to frame with screw from Step 1A without completely tightening screw.
Step C: Using the Back Plate as a guide, mark second hole (shown on template) using a center
punch if necessary and repeat step 1A drilling / tapping procedure.
Step D: With the Back Plate in the correct position and level with the frame, tighten screws from
steps 1B and 1C.
Step E: Using the Back Plate as a guide, drill and tap remaining 8 holes in the frame using drilling
/ tapping procedure from step 1A. Tighten screws.
Step F: Measure and mark track mounting holes. Drill using #16 drill bit . Attach track using
supplied wood / sheet metal screws.
Note:
the white plastic slide and black end caps
must be in the track before screws can attach the track to the door. Slider must slide
freely in track.
A. Center Back Plate Board into groove
of back plate.
NOTE:
The Temp,
Encoder, and Motor connectors on
the Back Plate Board are positioned
toward the hinge edge of the plate.
B. Rotate retaining clips (shown at
right) to hold board in groove and
tighten Phillips screw to secure in
place.
C. Repeat for second retaining clip.
Install Back Plate Board
2
Temp, Encorder,
Motor, & Fan
Connector
Back Plate
Board
Back Plate
Board
Retaining Clips to
Secure Board
To Back Plate
Groove in
Back Plate
Position Connector
1