Copyright © 2013, 2014 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
ASSA ABLOY
80-9356-0005-020 (01-14)
7
L2
115Y
L1
115/230VAC IN
MOTOR OUT
L2
230Y
U
V
W
STATUS LEDS
PUSH PULL
SW501
ON
H/O TQ
H/O TM
OBSTR
SENS
P1
M/DLY
P2
1
2
1
6
COM
SNS
COM
PB
K1
K2
11
JMP503
NC
NO
TB501
E
1. Align Close Position Magnet with sensor.
2. Turn power on at the Unit On/Off Switch
located on the end cap.
3. Turn Breaker Switch to "Reset" (Breaker
Switch shown in step 8). Red LED in
breaker should be on and circuit board
LEDs should illuminate.
Inverter Control Board Adjustments:
Based on function adjustment desired, use
table below to determine which POT is to
be adjusted.
Required:
Magnets must be adjusted for
specific application.
WARNING
ELECTRIC SHOCK RISK!
(Adjustments made in the shaded
area should be performed by
Authorized Factory Personnel.)
POT
FUNCTION
DESCRIPTION
OBSTR SENS
Obstruction Detection on Open
CW - Increase
CCW - Decrease
M/DLY
Motor Delay on Opening
CW - Increase
CCW - Decrease
P1
Sweep Closing Force (90° - 20°)
CW - Increase
CCW - Decrease
H/O TM
Hold Open Time (5 - 30 Seconds)
CW - Increase
CCW - Decrease
P2
Latch Force (20° - 0°)
CW - Increase
CCW - Decrease
H/O TQ
Motor Torque at Hold Open
Backcheck Position
CW - Increase
CCW - Decrease
E
Power-On Procedures
9
Control Set-Up
10
ADJUSTMENT TABLE
Signage
11
Affix "Caution" Labels on both sides
of the door. Labels should be
centered across the width of the door
and 50" from the floor.
Center
50"
Open Position
Magnet
Close Position Magnet
Sensor