Installation Instructions
Tools Required:
• Drill
• 10.0mm Drill Bit
• 3.0mm Drill Bit
• Phillips Screwdriver
Door Specifications:
ø10mm
ø10mm
ø10mm
20mm
20mm
Centre line of fixing
screw holes
1. Fixing Holes Required in Frame
Refer to door specification drawing to determine hole
centres. Drill three holes into the door frame ø10mm, the top
and bottom holes spaced 20mm from centre hole and inline
vertically. Remove any burs from the edge of the holes.
Note:
The centre fixing hole should be at least 1.5m from the
floor to comply with swimming pool fencing regulations
.
Ensure beak
points down
3. Assemble Latch
Insert the latch to the inside chassis assembly.
Snib tabs away
from door frame
Snib tabs away
from door frame
2. Fitting Chassis Assemblies to Frame
Align chassis assemblies to either side of doorframe. Screw the chassis to the door frame
(do not tighten at this stage) using the 2 x M4 fixing screws provided. Ensure the snib lever is
facing away from the door jamb.
Application:
Self latches sliding door on closure.
Pack Contents:
2 x Chassis
Assemblies
Inside Cover
Outside Cover
Strike Cover
Screw Pack
Strike
Latch
Drive Bar
Sliding Door Latch
