Instruction Manual
Public Mode (One -time Use)
b
Lock the door
Close the cabinet door and enter your passcode
a
Passcode length
How to configure
4 Digit
5 to 12 Digits
Press any four digits
Press + 5 to 12
(ex : 1 2 3 4)
(ex : 1 2 3 4)
(ex : 1 2 3 4)
문을
열때
Private Mode (On-going Use)
Enter the registered pass code
Rotate the knob to the locked position
and open the door
a
b
문을
잠글
때
Close the door and turn the knob
to the locked position
a
Using the Master Code
Important Note
· Factory Master Code
“ 3 5 2 6 ”
Two code levels
Master
Code
User
Code
An existing user code is deleted
when a valid Master Code is
entered.
The User Code will need to be set
again during programming of
private mode.
Press + “Master Code” +
Beep-Beep-Beep-Beep-Beep-
- Listen for extended beep
- Unlock the lock with short beep 5x followed by 5x
flashing Red LED's
a
b
Rotate the knob to the unlocked position and
open the door.
- this is confirmed by three red flashes followed
by a standard beep ( Sol-Do~)
-this is confirmed by three yellow flashes followed
by a long beep (Do-Mi-Sol~)
b
Enter the passcode you used to lock the door
a
Rotate the knob to the unlocked position
and open the door
Flashes
3 times
※
Private Mode (On-going Use)
- when the knob is rotated to the locked position
the cabinet lock will lock in 3 seconds.
a
a
Rotate the knob to the locked position
a
a
b
(ex : # 3 5 2 6 #)
Emergency Power
d
a
c
b
Step 1
Step 2
a
b
b
c
d
Sol-Do~
Do-Mi-Sol~
Flashes
3 times
Do-Mi-Sol~
Flashes
3 times
Sol-Do~
Step 1
Step 2
Do-Mi-Sol~
Flashes
5 times
Do-Mi-Sol~
Sol-Do
#
*
Connect a standard 5 pin Micro USB cable to
the USB port on the right side of the lock
When power is applied, both LED's flash
5x followed by an extended beep
Enter a valid User Code or Master Code to unlock
the cabinet
-An existing user code is deleted when a valid
Master Code is entered.
-The User Code will need to be set again during
programming of private mode.
Open the door and change the batteries
Package contents
Unlock the door
Unlock the door
Lock the door
a
Flashes
3 times
b
b
-this is confirmed by three yellow flashes followed
by a long beep (Do-Mi-Sol~)
One (1) HES KP20 cabinet lock
One (1) Rubber washer
One (1) M6 nut
One (1) Flat and one (1) Offset Locking Cam
Two (2) M4 washers
Five (5) Pan Head Phillips Screws
M4 x10mm locking cam screw
M4 x10mm (1-5mm thick door)
M4 x 20 mm (10-15mm thick door)
M4 x 25 mm (15-20mm thick door)
M4 x 30 mm (20-25mm thick door)
※
Public Mode (One-Time use)
- Previously used passcode will be erased
after unlock and stay open for next user.
1
2
3
4
5
6
6-1
6-2
Hardware installation
1
2
3
4
5
6-1
5
6-2
b
Ø13/64"
(5 mm)
Ø11/16"
(17 mm)
5-5/64" (129 mm)
Flashes
5 times
Installation T
emplate
Caution
-Risk of explosion if battery is replaced
by an incorrect type.
-Please only use new alkaline batteries.
※
Power : 4.5V (Alkaline AAA 1.5V x 3)
HES KP20 (12-button keypad) stand-alone cabinet lock
LED Feedback
-Red
-Yellow
-Amber
Audio Feedback
Short Beep - "Beep-"
Std. Beep - "Sol-Do~"
Long Beep - "Do-Mi-Sol~"
-this is confirmed by three red flashes followed
by a standard beep (Sol-Do~)
The cabinet lock will automatically lock in 3 seconds
b
