40
EN
Mounting
A
ttention!
Do not drill into the device:
You will damage the escape door locking system if
you drill any additional holes in it.
Protect against the penetration of dirt and chippings:
The escape door lock-
ing system can be damaged from the penetration of chips or dirt.
Clean the lock pocket before installation:
Before installing the escape door
locking system in the door or door frame, the lock pocket and all holes must
be cleaned (blown out or vacuumed). The escape door locking system can be
damaged if chippings or shavings fall inside.
Tension-free installation:
The escape door locking system must be installed
without tension. Check whether the door stops properly and does not show any
signs of warping before mounting.
Observe the tolerances for the voltage supply
: The operating voltage mea-
sured on the escape door locking system at rated current must lie within the
specified tolerance limits. Damage and malfunctions will occur if the tolerance
limits are exceeded or not reached.
Check the escape door locking system after installation:
The escape door
locking system must operate consistently smoothly for all functions. The bolt
must move easily when closing. Irregular or sluggish bolt movement may indi-
cate that the bolt was mounted incorrectly or was twisted when installed.
Installation in a normal position for locks:
Large leverage forces arise on doors,
whereby the lock, door frame and door leaf can be damaged when the installa-
tion position is incorrect. The escape door locking system must be installed as
far away from the door hinge as possible (Fig. 3).
Summary of Contents for Effeff 352M.80
Page 87: ...86 FR...
Page 88: ...87 FR...
