Drill 3X
Ø 1/8"
Holes
BACKPLATE
BACKPLATE
BACKPLATE
BACKPLATE
Secure with TORX Screw
Ensure reader is
fully seated
on backplate
TORX BIT
READER
READER
READER
READER
Wrap grommet
on cable
Press grommet
into backside
of backplate
Install 2X AA
lithium batteries
into the reader
Reader cable
exit hole
Apply RTV/sealant to 3X holes
prior to fastening 3X Screws
Mount to door with 3X
#4 X 3/8" self-tapping screws
(apply RTV/sealant to holes))
Reader Mounting
1
PERFORM a site survey to ensure
the opening is appropriate for
the DL100 installation and the
RF capability is optimum.
2
CONFIRM center of cylinder prep to
bottom of reader backplate is not
more than 5-1/4", see
Diagram 2B
.
3
REMOVE the backplate from the reader.
4
DRILL 3X 1/8" DIA. holes in the
backplate as indicated (deburr the
holes after drilling) See
Diagram 8.
5
POSITION reader in desired location
on door. See
Diagram 2B
.
6
Using backplate as a template, MARK and
DRILL 3X 7/64" DIA. holes and 1X 3/8"
DIA. hole in the door. Deburr 3/8" DIA.
hole after drilling. See
Diagram 2B
.
7
INSTALL 2X AA lithium batteries
into the reader, see
Diagram 9.
8
INSERT reader cable thru exit hole
on backplate, see
Diagram 10
.
9
WRAP grommet on cable, and PRESS
grommet into hole on backside of
backplate see
Diagram 10
.
10
APPLY RTV/Sealant to 3X holes
on backplate prior to fastening
3X screws, see
Diagram 11
.
11
MOUNT backplate to door with
the provided 3X #4 X 3/8” self-
tapping screws, see
Diagram 11
.
12
SECURE reader to backplate with
the provided tamper resistant Torx screw,
fasten with Torx bit, see
Diagram 12
.
NOTE: Ensure reader is fully seated on backplate.
DIAGRAM 8:
Backplate drill holes
DIAGRAM 9:
Batteries into cover
DIAGRAM 10:
Grommet on cable
DIAGRAM 11:
Mount to door
DIAGRAM 12:
Secure cover to backplate
3
of 8
