39
FDD connector
(33-pin FLOPPY1)
(see p.14 No. 33)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
2.12 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA2 Connectors
These four Serial ATA2 (SATA2)
(SATA2_2_3: see p.14, No. 15)
connectors support SATA data
(SATA2_4_5: see p.14, No. 16)
cables for internal storage
devices. The current SATA2
interface allows up to 3.0 Gb/s
data transfer rate.
Serial ATA3 Connectors
These four Serial ATA3 (SATA3)
(SATA3_A1_A2: see p.14, No. 13)
connectors support SATA data
(SATA3_0_1: see p.14, No. 14)
cables for internal storage
devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate. If the eSATA3
port on the rear I/O has been
connected, the internal
SATA3_A2 will not funtion.
Serial ATA (SATA)
Either end of the SATA data
Data Cable
cable can be connected to the
(Optional)
SATA / SATA2 / SATA3 hard
disk or the SATA2 / SATA3
connector on this motherboard.
SA
TA2_4 SA
TA2_2
SA
TA2_5 SA
TA2_3
SA
TA3_0 SA
TA3_A1
SA
TA3_1 SA
TA3_A2
the red-striped side to Pin1
