2 4
2 4
2 4
2 4
2 4
ASRock X48TurboTwins-WiFi Motherboard
EnglishEnglishEnglishEnglishEnglish
2.9 HDMI_SPDIF Header Connection Guide
2.9 HDMI_SPDIF Header Connection Guide
2.9 HDMI_SPDIF Header Connection Guide
2.9 HDMI_SPDIF Header Connection Guide
2.9 HDMI_SPDIF Header Connection Guide
HDMI (High-Definition Multi-media Interface) is an all-digital audio/video specification,
which provides an interface between any compatible digital audio/video source, such as
a set-top box, DVD player, A/V receiver and a compatible digital audio or video monitor,
such as a digital television (DTV). This motherboard is equipped with a HDMI_SPDIF
header, which provides SPDIF audio output to HDMI VGA card, allows the system to
connect HDMI Digital TV/projector/LCD devices. To use HDMI function on this
motherboard, please refer to page 33 of “User Manual” in the support CD for detailed
installation procedures.
2.10 eSA
2.10 eSA
2.10 eSA
2.10 eSA
2.10 eSATTTTTAII Inter
AII Inter
AII Inter
AII Inter
AII Interface Introduction
face Introduction
face Introduction
face Introduction
face Introduction
eSATAII connectors
(eSATAII_TOP and
eSATAII_BOTTOM)
NOTE:
1. If you set “Configure SATAII as” option in BIOS setup to AHCI or RAID mode, Hot
Plug function is supported with eSATAII devices. Therefore, you can insert or
remove your eSATAII devices to the eSATAII ports while the system is power-on and
in working condition.
2. If you set “Configure SATAII as” option in BIOS setup to IDE mode, Hot Plug function
is not supported with eSATAII devices. If you still want to use eSATAII function in IDE
mode, please insert or remove your eSATAII devices to the eSATAII ports only when
the system is power-off.
3. Please refer to page 26 to 28 for detailed information of RAID mode, IDE mode, and
AHCI mode.
How to install eSATAII?
SATAII connectors
(SATAII_5 (Port4) and
SATAII_6 (Port5))
1.
If you just plan to install one eSATAII device to this motherboard, it is recom-
mended to enable the bottom eSATAII port of the I/O shield. In order to enable
the bottom eSATAII port of the I/O shield, you need to connect one of the orage
SATAII connectors (SATAII_6 (Port5); see p.2 No.20) and one of the orange
eSATAII connectors (eSATAII_BOTTOM; see p.2 No.3) with a SATA data cable
first. Then the bottom eSATAII port of the I/O shield is enabled.
