ASROCK PENRYN1600SLI-110DB, Installation Manual

Page: 21 / 172

2 1 2 1 2 1 2 1 2 1
ASRock Penryn1600SLI-110dB Motherboard
2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.2 No. 24)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE Connector (Blue) Secondary IDE Connector (Black)
(39-pin IDE1, see p.2 No. 10) (39-pin IDE2, see p.2 No. 9)
Note: If you use only one IDE device on this motherboard, please set the IDE
device as “Master”. Please refer to the instruction of your IDE device vendor
for the details. Besides, to optimize compatibility and performance, please
connect your hard disk drive to the primary IDE connector (IDE1, blue) and
CD-ROM to the secondary IDE connector (IDE2, black).
Serial ATAII Connectors These four Serial ATAII (SATAII)
(SATAII_1: see p.2, No. 15)
connectors support SATA data
(SATAII_2: see p.2, No. 12)
cables for internal storage
(SATAII_3: see p.2, No. 14)
devices. The current SATAII
(SATAII_4: see p.2, No. 13)
interface allows up to 3.0 Gb/s
data transfer rate.
Serial ATA (SATA) Either end of the SATA data cable
Data Cable can be connected to the SATA /
(Optional)
SATAII hard disk or the SATAII
connector on this motherboard.
connect the black end
to the IDE devices
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
the red-striped side to
Pin1
EnglishEnglishEnglishEnglishEnglish
SATAII_1 SATAII_3
SATAII_2 SATAII_4