ASROCK P4I65PE-M, Installation Manual

Page: 10 / 74

1 0 1 0
1 0 1 0 1 0
ASRock P4i65PE-M Motherboard
EnglishEnglishEnglishEnglishEnglish
2.4 Jumpers Setup 2.4 Jumpers Setup
2.4 Jumpers Setup 2.4 Jumpers Setup
2.4 Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is “SHORT”. If no jumper cap
is placed on the pins, the jumper is “OPEN”.
The illustration shows a 3-pin jumper whose
pin1 and pin2 are “SHORT” when jumper cap
is placed on these 2 pins.
Jumper Setting Description
PS2_USB_PWR1 Short pin2, pin3 to enable
(see p.2 No. 1)
+5VSB (standby) for PS/2
or USB wake up events.
Note: To 5VSB, it requires 2 Amp and higher standby current provided by
power supply.
JR1
(see p.2 No. 24)
JL1
(see p.2 No. 24)
Note: If the jumpers JL1 and JR1 are short, both the front panel and the rear panel
audio connectors can work.
Clear CMOS
(CLRCMOS0, 2-pin jumper)
(see p.2 No. 18)
Note: CLRCMOS0 allows you to clear the data in CMOS. The data in CMOS includes
system setup information such as system password, date, time, and system
setup parameters. To clear and reset the system parameters to default setup,
please turn off the computer and unplug the power cord, then use a jumper
cap to short the pins on CLRCMOS0 for 3 seconds. Please remember to
remove the jumper cap after clearing the CMOS. If you need to clear the
CMOS when you just finish updating the BIOS, you must boot up the system
first, and then shut it down before you do the clear-CMOS action.
2-pin jumper
Short Open