ASROCK K7VM3, Installation Manual, Page: 10 / 64

1 0 1 0
1 0 1 0 1 0
ASRock K7VM3 Motherboard
2.5 Connectors 2.5 Connectors
2.5 Connectors 2.5 Connectors
2.5 Connectors
Connectors are NOT jumpers. DO NOT place jumper caps over these
connectors.
Connector Figure Description
FDD connector
(33-pin FLOPPY1)
(see p.2 item 19)
Note: Match the red marking on the floppy ribbon cable with Pin1.
Primary IDE connector (Blue) Secondary IDE connector (Black)
(39-pin IDE1, see p.2 item 10) (39-pin IDE2, see p.2 item 9)
Connector this BLUE end Connect this BLACK end
to the motherboard to the IDE devices
Note:To optimize compatibility and performance, please connect your hard disk
drive to the primary IDE connector (IDE1, blue) and CD-ROM to the
secondary IDE connector (IDE2, black).
USB 2.0 header ASRock I/O
TM
already
(9-pin USB45)
provided 4 default USB 2.0
(see p.2 item 20)
ports. If the 4 USB 2.0 ports
on the rear panel are not
sufficient, this USB 2.0 header
is available to support 2
additional USB 2.0 ports.
Infrared module connector This connector supports an
(5-pin IR1)
optional wireless transmitting
(see p.2 item 21)
and receiving infrared module.
Internal audio connectors These connectors allow you
(4-pin CD1, 4-pin AUX1)
to receive stereo audio input
(CD1: see p.2 item 29)
from sound sources such as
(AUX1: see p.2 item 30)
a CD-ROM, DVD-ROM, TV
tuner card, or MPEG card.
80-Pin ATA 100/133 cable
red marking
CD1 AUX1
EnglishEnglishEnglishEnglishEnglish