ASROCK K7UPGRADE -, Installation Manual

Page: 16 / 88

ASRock K7Upgrade-600 Motherboard
1 6 1 6
1 6 1 6
1 6
2.6 2.6 2.6 2.6 2.6 Serial A Serial A Serial A Serial A Serial ATTTTTA (SA A (SA A (SA A (SA A (SATTTTTA) Hard Disks Installation A) Hard Disks Installation A) Hard Disks Installation A) Hard Disks Installation A) Hard Disks Installation
This motherboard supports Serial ATA (SATA) hard disks. This section will guide
you to install the SATA hard disks.
STEP 1: Install the SATA hard disks into the drive bays of your chassis.
STEP 2: Connect the SATA power cable to the SATA hard disk.
STEP 3: Connect one end of the SATA data cable to the motherboard’s SATA
connector.
STEP 4: Connect the other end of the SATA data cable to the SATA hard disk.
2.7 2.7 2.7 2.7 2.7 Hot Plug and Hot Swap F Hot Plug and Hot Swap F Hot Plug and Hot Swap F Hot Plug and Hot Swap F Hot Plug and Hot Swap Functions for SA unctions for SA unctions for SA unctions for SA unctions for SATTTTTA HDDs A HDDs A HDDs A HDDs A HDDs
K7Upgrade-600 motherboard supports Hot Plug and Hot Swap functions for
SATA devices.
NOTE
What is Hot Plug Function?
If the SATA HDDs are NOT set for RAID configuration, it is called “Hot
Plug” for the action to insert and remove the SATA HDDs while the
system is still power-on and in working condition.
However, please note that it cannot perform Hot Plug if the OS has
been installed into the SATA HDD.
What is Hot Swap Function?
If SATA HDDs are built as RAID1 then it is called “Hot Swap” for the
action to insert and remove the SATA HDDs while the system is still
power-on and in working condition.
EnglishEnglishEnglishEnglishEnglish