ASROCK H510TM-ITX, Manual

Page: 21 / 170

English
19
H510TM-ITX
CPU Fan Connector
(4-pin CPU_FAN1)
(see p.1, No. 15) This motherboard
provides a 4-Pin CPU fan
(Quiet Fan) connector.
If you plan to connect a
3-Pin CPU fan, please
connect it to Pin 1-3.
ATX 19V Power
Connector
(4-pin ATX_PWR1
(see p.1, No. 1) Please connect an ATX
19V power supply to this
connector.
*The power supply plug
fits into this connector in
only one orientation.
FPD Brightness Header
(8-pin BLT_VOL1)
(see p.1, No. 9) 1: BKLT_PWR
2: BKLT_PWR
3: BKLT_EN
4: BKLT_PWM
5: GND
6: GND
7: Brightness_Up
8: Brightness_Down
GND
FAN_VOLTAGE
CPU_FAN_SPEED
FAN_SPEED_CONTROL
1
2
3
4
+19V
GND GND
+19V
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis must sup-
port HDA to function correctly. Please follow the instructions in our manual and chassis
manual to install your system.
2. If you use an AC’97 audio panel, please install it to the front panel audio header by the
steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don’t need to connect
them for the AC’97 audio panel.
E. To activate the front mic, go to the “FrontMic” Tab in the Realtek Control panel and
adjust “Recording Volume”.
1 8