English
20
Serial ATA3 Connectors
(SATA3_0:
see p.1, 3, No. 8)
(SATA3_1:
see p.1, 3, No. 9)
(SATA3_2:
see p.1, 3, No. 7)
(SATA3_3:
see p.1, 3, No. 6)
These four SATA3
connectors support SATA
data cables for internal
storage devices with up to
6.0 Gb/s data transfer rate.
* If M2_1 is occupied by
a SATA-type M.2 device,
SATA3_3 will be disabled.
USB 2.0 Headers
(9-pin USB_4_5)
(see p.1, No. 14 or p.3, No.
15)
(9-pin USB_6_7)
(see p.3, No. 14)
There is one header on
H410M-HDVP and two
headers on H410M-
HDVP2. Each USB 2.0
header can support two
ports.
USB 3.2 Gen1 Header
(19-pin USB3_2_3)
(see p.1, 3, No. 5)
There is one header on
this motherboard. This
USB 3.2 Gen1 header can
support two ports.
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 19 or p.3, No.
20)
This header is for
connecting audio devices
to the front audio panel.
1
In
Dummy
IntA_PB_D-
GND
IntA_
GND
IntA_PB_SSTX-
IntA_
IntA_PB_SSRX-
Vbus
Vbus
Vbus
IntA_PA_SSRX-
IntA_
GND
IntA_PA_SSTX-
IntA_
GND
IntA_PA_D-
In
SA
TA3_2
SA
TA3_3
SA
TA3_0
SA
TA3_1
J_SENSE
OUT2_L
MIC_RET
PRESENCE#
GND
OUT2_R
MIC2_R
MIC2_L
OUT_RET
1
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
2. If you use an AC’97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don’t need to
connect them for the AC’97 audio panel.
E. To activate the front mic, go to the “FrontMic” Tab in the Realtek Control panel
and adjust “Recording Volume”.
DUMMY
GND
GND
P+
P-
USB_PWR
P+
P-
USB_PWR
1