ASROCK AM2V890-VSTA, User Manual

Page: 20 / 128

2 0 2 0
2 0 2 0 2 0
ASRock AM2V890-VSTA Motherboard
EnglishEnglishEnglishEnglishEnglish
2.10 2.10 2.10 2.10 2.10 Driver Installation Guide Driver Installation Guide Driver Installation Guide Driver Installation Guide Driver Installation Guide
To install the drivers to your system, please insert the support CD to your optical
drive first. Then, the drivers compatible to your system can be auto-detected and
listed on the support CD driver page. Please follow the order from up to bottom
side to install those required drivers. Therefore, the drivers you install can work
properly.
2.8 Serial A 2.8 Serial A
2.8 Serial A 2.8 Serial A
2.8 Serial ATTTTTA (SA A (SA
A (SA A (SA
A (SATTTTTA) Hard Disks Installation A) Hard Disks Installation
A) Hard Disks Installation A) Hard Disks Installation
A) Hard Disks Installation
This motherboard adopts VIA
®
8237A southbridge chipset that supports Serial ATA
(SATA) hard disks and RAID (RAID 0, RAID 1, and JBOD) functions. You may install
SATA hard disks on this motherboard for internal storage devices. This section
will guide you to install the SATA hard disks.
STEP 1: Install the SATA hard disks into the drive bays of your chassis.
STEP 2: Connect the SATA power cable to the SATA hard disk.
STEP 3: Connect one end of the SATA data cable to the motherboard’s SATA
connector.
STEP 4: Connect the other end of the SATA data cable to the SATA hard disk.
2.9 Hot Plug and Hot Swap F 2.9 Hot Plug and Hot Swap F 2.9 Hot Plug and Hot Swap F 2.9 Hot Plug and Hot Swap F 2.9 Hot Plug and Hot Swap Functions for SA unctions for SA unctions for SA unctions for SA unctions for SATTTTTA HDDs A HDDs A HDDs A HDDs A HDDs
AM2V890-VSTA
motherboard supports Hot Plug and Hot Swap functions for SATA
Devices.
NOTE
What is Hot Plug Function?
If the SATA HDDs are NOT set for RAID configuration, it is called “Hot
Plug” for the action to insert and remove the SATA HDDs while the system
is still power-on and in working condition.
However, please note that it cannot perform Hot Plug if the OS has been
installed into the SATA HDD.
What is Hot Swap Function?
If SATA HDDs are built as RAID1 then it is called “Hot Swap” for the action
to insert and remove the SATA HDDs while the system is still power-on
and in working condition.