ASROCK ALIVESATA2-GLAN, Installation Manual, Page: 14 / 160

1 4 1 4
1 4 1 4 1 4
ASRock ALiveSATA2-GLAN Motherboard
EnglishEnglishEnglishEnglishEnglish
2.5 Onboard Headers and Connectors 2.5 Onboard Headers and Connectors
2.5 Onboard Headers and Connectors 2.5 Onboard Headers and Connectors
2.5 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place jumper
caps over these headers and connectors. Placing jumper caps over the
headers and connectors will cause permanent damage of the motherboard!
FDD Connector
(33-pin FLOPPY1)
(see p.2, No. 22)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
the red-striped side to Pin1
connect the black end
to the IDE devices
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
SATAII_1 SATAII_2
Primary IDE Connector (Blue) Secondary IDE Connector (Black)
(39-pin IDE1, see p.2, No. 13) (39-pin IDE2, see p.2, No. 14)
Note: If you use only one IDE device on this motherboard, please set the IDE
device as “Master”. Please refer to the instruction of your IDE device vendor
for the details. Besides, to optimize compatibility and performance, please
connect your hard disk drive to the primary IDE connector (IDE1, blue) and
CD-ROM to the secondary IDE connector (IDE2, black).
Serial ATA Connectors (Black) These two Serial ATA (SATA)
(SATA1: see p.2, No. 17)
connectors are supported by
(SATA2: see p.2, No. 15)
VIA
®
VT8237A southbridge,
support SATA data cables for
internal storage devices. The
current SATA interface allows
up to 1.5 Gb/s data transfer
rate.
Serial ATA II Connectors (Red) These two Serial ATAII (SATAII)
(SATA II_1: see p.2, No. 27)
connectors are supported by
(SATA II_2: see p.2, No. 21)
JMicron ® JMB 363 (PCIE x1
interface), support SATA
data cables for internal storage
devices. The current SATAII
interface allows up to 3.0 Gb/s
data transfer rate.
SATA1
SATA2