ASROCK 939Dual-SATA2, Installation Manual

Page: 16 / 96

1 6 1 6
1 6 1 6 1 6
ASRock 939Dual-SATA2 Motherboard
EnglishEnglishEnglishEnglishEnglish
2.8 2.8
2.8 2.8
2.8 Making a SA Making a SA
Making a SA Making a SA
Making a SATTTTTA Driver Disk A Driver Disk
A Driver Disk A Driver Disk
A Driver Diskette F ette F
ette F ette F
ette For SA or SA
or SA or SA
or SATTTTTA Operation in A Operation in
A Operation in A Operation in
A Operation in
“RAID” Mode “RAID” Mode “RAID” Mode “RAID” Mode “RAID” Mode
If you want to install Windows 2000, Windows XP, or Windows XP 64-bit OS on your
SATA HDDs, you will need to make a SATA driver diskette before you start the OS
installation.
STEP 1: Insert the ASRock Support CD into your optical drive to boot your system.
(Do NOT insert any floppy diskette into the floppy drive at this moment!)
STEP 2: During POST at the beginning of system boot-up, press <F11> key, and
then a window for boot devices selection appears. Please select CD-
ROM as the boot device.
STEP 3: When you see the message on the screen, “Do you want to generate
Serial ATA driver diskette [YN]?”, press <Y>.
STEP 4: Then you will see these messages,
Please insert a diskette into the floppy drive.
WARNING! Formatting the floppy diskette will
lose ALL data in it!
Start to format and copy files [YN]?
Please insert a floppy diskette into the floppy drive, and press <Y>.
STEP 5: The system will start to format the floppy diskette and copy SATA drivers
into the floppy diskette.
2.9 2.9 2.9 2.9 2.9 SA SA SA SA SATTTTTA Operating in “non-RAID” Mode A Operating in “non-RAID” Mode A Operating in “non-RAID” Mode A Operating in “non-RAID” Mode A Operating in “non-RAID” Mode
If you want to install Windows 2000, Windows XP, or Windows XP 64-bit OS on your
SATA HDDs operating in non-RAID mode, you don’t need to make a SATA driver
diskette before OS installation.
Windows 98 SE and Windows ME must be installed by SATA operating in
RAID mode, and you don’t need to make a SATA driver diskette for these
two OS before OS installation.
Once you have the SATA driver diskette ready, you may start to install Windows 2000
/ Windows XP / Windows XP 64-bit on your system directly without setting the RAID
configuration on your system, or you may start to use “RAID Installation Guide” to set
RAID 0 / RAID 1 / JBOD configuration before you install the OS. Before you start to
configure the RAID function, you need to check the installation guide in the Support CD
for proper configuration. Please find the document, “Guide to SATA Hard Disks Installa-
tion and RAID Configuration”, at the following path in the Support CD:
.. \ Information \ Manual \ RAID Installation Guide \ English.pdf